5 minutes quick dry two component AB glue

WKglues 5 minutes quick dry two component AB glue Is room temperature or temperature curing epoxy resin, the cured surface is flat, bright, high hardness, good insulation performance.

1.Weigh the glue to be blended according to the weight ratio in the specification book.

2. After weighing, use a clean wooden stick or iron rod or mixing tube to stir well, stirring in the same direction. When stirring, keep scraping the bottom of the container and around the container, the mixing tool is best to use a rough appearance, so that you can stir evenly, stirring time is about 1-2 minutes. (room temperature 25℃)

3. In the normal production of glue, it is best to control the amount of each stirring of this model (bonding glue) at about 3G, and the mixing ratio is A: B= 1:1, please follow the normal ratio of the specification.

4. The mixing container is the best round, such as the round glue bucket, the glue is mixed evenly with the glue container cup or stainless steel cup, poured into the product that needs to be filled with glue, the operating temperature is best to keep at room temperature 25℃ or so, so as to ensure the normal solidification of the glue. When the temperature of the operating environment increases, the mixing weight of each glue can be appropriately reduced, which can extend the operating time and curing time, and the weight of each glue adjustment can be appropriately adjusted as the temperature increases and decreases.

5. Such as bonding relatively large components or require good surface luster, no bubbles. Can be divided into 2 sealing glue, sealing the first glue after the initial drying of the second glue.

6. The curing time of this kind of glue is: (25℃ X5min) (25℃) the surface is initially dried for about 5-10min, and (25℃) the whole dry for about 24 hours. After curing, the surface adhesion is strong, the gloss is good, the hardness is between 77 degrees and 83 degrees, the insulation performance, moisture-proof and waterproof performance is excellent, and it is used for the potting moisture-proof and waterproof protection of various electronic products.

Seven. The curing time of this kind of glue is directly related to the amount of weight deployed, and the more deployed, the faster the curing, and the less deployed, the slower the curing. The curing time of this kind of glue also has a direct impact on the temperature of the environment, the higher the temperature the faster the curing, the lower the temperature the slower the curing. When the weather is cold, please preheat the A glue properly before deploying it, so as to facilitate operation. The preheating temperature is 35-45 degrees, and the whole barrel can be preheated until it becomes thin and easy to stir.

8. A glue may have A small amount of settlement when it is placed for more than 180 days. Before use, A glue should be stirred evenly before matching with B glue.

9. Storage method: It should be stored in a spacious, ventilated, dry and cool place to prevent the inhalation of moisture and avoid direct sunlight. Any material that is not used for the day must be covered and kept sealed. A, B mixing process, there will be heat phenomenon, this situation is completely normal.

10. Precautions: When the skin is accidentally dirty during operation, you can scrub it directly with soap mixed with cotton cloth. If you accidentally get eyes, please rinse with water as soon as possible, serious please go to the hospital as soon as possible. (1) If any material goes into the mouth, you should drink a few cups of water and go to the hospital in time, (2) If contact with curing agent causes skin allergy, you can soak in acetic acid dilute solution for 10-20 minutes. (3) Errant eyes can be washed with 10% sterile edible saline, and go to the nearest hospital.